7. CUSTOMIZING YOUR UNIT
7-28
Displaying Loran C TDs
1. Select GRI, then press the EDIT soft key to show the GRI & station pair window.
GRI & STATION PAIR
U.S. WEST COAST
9940 11-27
▲
▼
▼
Loran GRI & station pair window
2. Adjust the Trackball
upward or downward to select GRI code.
3. Roll the Trackball rightward to show the display below, to enable selection of station
pair.
GRI & STATION PAIR
U.S. WEST COAST
11-279940
▲
▼
▼
Loran C GRI & station pair window
4. Adjust the Trackball vertically to select station pair.
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter a position offset to refine Loran C position accuracy. Select
(GRI) CORRECTION 1 or CORRECTION 2, then press the EDIT soft key. Enter
correction value with the Trackball and alphanumeric keys. Use the +
< − −> - soft key to
switch from plus to minus and vice versa. Press the ENTER soft key or push the ENTER
knob.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select “LORAN C” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”
10. Press the MENU key twice to close the menu.
Displaying DECCA TDs
1. Select CHAIN, then press the EDIT soft key to show the chain & station pair window.
CHAIN STATION PAIR
S BALTIC
01 R-G
▲
▼
▼
Decca chain and station pair window
To Next Page
Loading...
Need help?
General
