2. HOW TO SETUP THE MENU
13
*1
: Grayed out when the SC-33 is connected.
Dimensions/
CCRP
CALC-SPD-POSN Z Set the height for calculating the 3-axis
speed. Enter the distance from the bot-
tom of the ship to the position where
you want to measure the ship’s speed.
For example, enter the draft value when
you want to measure the speed at draft
position.
Depends on the
ship’s height.
Sensor
Smoothing
HDG
*1
Set the time delay (smoothing) for
heading data output.
0 to 9999 sec
3-Axis Speed
*1
Set the time delay (smoothing) for 3-
axis speed data output.
0 to 9999 sec
ROT
*1
Set the time delay (smoothing) for ROT
data output.
0 to 30 sec
DR Time
When the SATELLITE COMPASS
™
cannot receive the signal from the sat-
ellite, the SATELLITE COMPASS
™
keeps outputting the heading data to
use dead reckoning for the time set
here. If the signal from the satellite can-
not be retrieved within the time set here,
the SATELLITE COMPASS
™
stops
outputting the heading data.
0 to 5 min
Menu Item Remarks Setting range
To Next Page
Loading...
