Furuno TZT9 User Manual

5. ROUTES
5-2
3. Select the next route point in the route. A blue line with arrow runs between the
previous route point and the next route point. The arrow points in the direction of
route flow.
4. Select the next route point in the route.
Repeat this step to enter all route points. Each route point is numbered.
5. At the last route point, select [End Route] at the top right-hand corner of the screen
to complete the route. The flag mark disappears and the following window ap-
pears.
The route is automatically named. The default route name is “RTE” plus the date
(e.g. RTE 2012-03-01). Select [Save]. If necessary, select [Rename] to change
the route name. The route is saved to the routes list.
5.2.2 How to create a new route from a point
You can create a route from a point.
1. Select a point to display the pop-up menu.
2. Select [New Route]. The flag mark as below appears on the point.
3. Select the next route point in the route. A blue line with arrow runs between the
previous point and the next route point. The arrow points in the direction of route
flow.
1st route point (starting point)
2nd route
point
Route point
Route leg
Route point number
3rd route point
4th route point
A new route has been created under this name:
Rename
Save
Cancel
RTE 2012-03-01

Furuno TZT9 Specifications

General

Brand	Furuno
Model	TZT9
Category	Monitor
Language	English