14
Frame Grabber Setup Flow Chart
Start
Select VIDEO>Channels>Edit and set parameters as
below. Settings in parenthesis are reference only.
These parameters are set according to video signal.
Horizontal offset: 0
Vertical offset: 0
Horizontal sync polarity: (Positive)
Vertical sync polarity : (Positive)
Phase: 0
Horizontal resolution: (1280)
Vertical resolution: (1024)
Pixel rate: (according to resolution)
PLL (according to resolution)
Save image to web: Saved as JPEG
Sample rate: 15 seconds
Sync type: (Separate SYNC)
Press Calibrate button.
Press Test button.
Change following parameters
one at a time.
1) First, Vertical offset
2) Next, Horizontal offset
3) Then, PLL multiplier
From next page
Fig. 3.10 (1/2)
To Next Page
Loading...
