2. Once the bed is up to temperature, the printer will home its Z, Y, and X axes, in that order.
3. The printer will perform a self-calibration and bed leveling routine to ensure the bed is level and the
first layer height is correct. The print head will come up to temperature during this sequence. Watch
the screen for status updates and information on what the printer is doing.
4. Once the bed probing is complete, the print head will move to the front left corner, extrude some
filament in free air to prime the extruder, then the print will begin.
5. At the end of the print, the print head will move to the back-left corner and the bed will drop to the
bottom to make part removal easier.
6. For more information on part removal, see the Cleaning & Preparing the Bed section.
NOTE: If you open the main door during a print, the printer will automatically pause the print for
safety. To resume a print, close the main door and select "Resume" on the control panel.
To Next Page
Loading...
