4. For materials that require more than 1 layer of gluestick, apply the subsequent layers at 90 degrees to
the previous layer.
What Bed Coating to Use?
- For most materials, Fusion3 recommends purple gluestick like the one including with your toolkit.
- Please refer to the Fusion3 Certified Materials list where we provide a recommended number of layers
of glue stick to apply for each material
- For a given material, if you don't have information about bed coatings, assuming 2 layers of purple
gluestick.
- For polycarbonate and PC-blends, we recommend Magigoo-PC (NOTE this is NOT normal Magigoo).
- For nylons, gluestick works well, but Magigoo-PA is also fine to use.
To Next Page
Loading...
