FUTABA 12K - Page 12

12
<Before Use>
Your T12K includes the following components:
6SHFL¿FDWLRQVDQGUDWLQJVDUHVXEMHFWWRFKDQJHZLWKRXWQRWLFH
• T12K Transmitter
• R3008SB Receiver
• HT5F1800B NiMH battery & Charger
*The set contents depend on the type of set.
Transmitter T12K
(2-stick, 14-channel, T-FHSS Air-2.4G system)
Frequency band
: 2.4GHz band
RF power output
:
100mW EIRP
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V HT5F1800B NiMH battery
Receiver R3008SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS system)
Frequency band
: 2.4GHz band
RF power output
:
25mW EIRP
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)
Weight: 0.36 oz. (10.1g)
(*1) When using ESC's make sure that the regulated output capacity meets your usage application.
Note: The battery in the T12K transmitter is not connected to the battery
connector at initial. Please connect the battery connector before use.
ŶƜƖƗƈƐŃŦƒƐƓƄƗƌƅƌƏƌƗƜ
ŦƒƑƗƈƑƗƖŃƄƑƇŃŷƈƆƋƑƌƆƄƏŃŶƓƈƆƌƲƆƄƗƌƒƑƖ
The
12K
is a
2.4GHzT-FHSSAirsystem
. The transmitter can also be switched to
S-FHSS
. (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
NOTE：
*The Futaba
T-FHSSAir
system
cannot
be used with Futaba
S-FHSS/FASST/FASSTest
systems.
Use it with a
T-FHSSAir
system transmitter and receiver. The
T12K
is a
T-FHSSAirsystem
,
but can also be used with an
S-FHSS
receiver by switching to
S-FHSS
. However, in this case the
telemetry system cannot be used.
*The
T-FHSSAirsystem
and
T-FHSS
surface system are different. The
T12K
cannot be used with
the
R304SB,R304SB-E
or
T-FHSS
surface system receivers.
CommunicationsSystem
UsableReceivers(2017,11)
T-FHSSAir
R3006SB,R3008SB,
R3001SB
S-FHSS
R2001SB,R2008SB,
R2006GS,R2106GF