FUTABA 12K - Servo Speed

87
<Functions of Linkage Menu>
ŏ6HOHFWWKHIXQFWLRQQDPH
DQGUHWXUQWRWKH/LQNDJH
PHQXE\SXVKLQJWKH RTN
EXWWRQRUSXVKLQJWKH
HOME/EXITEXWWRQ
<Push Dial>
RETURN
SERVO SPEED
6HWVWKHVSHHGRIHDFKVHUYR
The speed of the servo from 1CH to 12CH of
operation can be set up.
It can adjust to 0-27.
Speed becomes slow as a numerical value's 0
increases in the state of the fastest of the servo.
* Speed cannot be made quicker than the maximal rate of the
servo to be used.
Servo speed setting
3XVKWKH6SHHGEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW
8VHWKHDGMXVWPHQWEXWWRQVWRDGMXVWWKH
VHUYRVSHHG
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
* It will overlap, if speed control of a S.BUS servo setup is
used at the time of S.BUS servo use, and speed changes.
Please use one either.
* The speed of THR is not set up simultaneously with THR
DELAY (model menu : only airplane).
ŏ6HOHFW>6(59263(('@LQWKH/LQNDJHPHQXDQG
DFFHVVWKHVHWXSVFUHHQVKRZQEHORZE\SXVKLQJ
WKH571EXWWRQ
(The display screen is an example. The
screen depends on the model type.)
6FUROOLQJ
ŏ0RYLQJFXUVRU
ŏ$GMXVWLQJYDOXH
ŏ7RQH[WSDJH
FKDQQHO
VSHHG
VSHHG
FKDQQHO