FUTABA 12K - Page 134

134
<Model Menu (Common Functions)>
 3XVKWKH571EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVRUPRGH
*Needle high trim works as high trim based on the center.
:RUNVOLNH$7/WULP
Ɣ$FFHOHUDWLRQVHWWLQJ$LUSODQH
*This function is used to adjust the needle/engine rise
characteristics during acceleration. This enables an
acceleration function which temporarily increases the needle
operation from the throttle stick.
This function is used when there are symptoms of the
mixture being too lean or too rich, which would be
generated by sudden throttle stick inputs.
 >$FFHOHUDWLRQUDWHVHWWLQJ5$7(@
$FFHOHUDWLRQFDQEHDGMXVWHGIRUERWKKLJKDQGORZVHWWLQJV
 >'DPSLQJUDWHVHWWLQJ'803,1*@
7KHUHWXUQWLPHDIWHURSHUDWLRQ'XPSLQJFDQEHVHW
 0RYHWKHFXUVRUWRWKHUDWHLWHP\RXZDQWWR
FKDQJHDQGSXVKWKH 571EXWWRQWRVZLWFK
WRWKHGDWDLQSXWPRGH
 $GMXVWWKHUDWHE\VFUROOLQJWKH3XVKGLDO
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 3XVKWKH571EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVRUPRGH
 >2SHUDWLRQSRLQWVHWWLQJ$&7326@
*The operation point at which the acceleration setting will
occur. If this point is exceeded, acceleration is performed.
 0RYH WKHFXUVRUWRWKH>$&7326@LWHPDQG
KROGWKHWKURWWOHVWLFNWRWKHSRVLWLRQ\RX
ZDQWWRFKDQJHDQGSXVKWKH571EXWWRQIRU
RQHVHFRQG
Note: When using the acceleration function,
since the needle stroke is large, adjust your
settings so there is no binding of your linkage.
Ɣ(QJLQHFXWVHWWLQJ
* Operation linked with the throttle hold function, throttle cut
function, and idle down function is possible. The throttle cut
position can be adjusted accordingly. Set it to the full closed
position.
 0RYHWKHFXUVRUWRWKHWKURWWOHFXWRULGOH
GRZQLWHPDQGSXVKWKH571EXWWRQWRVZLWFK
WRWKHGDWDLQSXWPRGH
 $GMXVWWKHVHUYRSRVLWLRQE\VFUROOLQJWKH3XVK
GLDO
 ,QLWLDOYDOXH7+5&87,'/('2:1
 $GMXVWPHQWUDQJH7+5&87a,'/(
'2:1a
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 3XVKWKH571EXWWRQWRHQGWKHDGMXVWPHQW
DQGUHWXUQWRWKHFXUVRUPRGH
6HWWLQJPHWKRG
%HIRUHXVLQJWKLVIXQFWLRQDVVLJQWKH>)8(/0,;@IXQFWLRQ
WRDQXQXVHGFKDQQHOLQWKH/LQNDJHPHQX>)81&7,21@
Ɣ$FWLYDWHWKHIXQFWLRQ
0RYHWKHFXUVRUWRWKH>$&7@LWHPDQGSXVK
WKH571EXWWRQWRVZLWFKWRWKHGDWDLQSXW
PRGH
 6HOHFWWKH$&7PRGHE\VFUROOLQJWKH 3XVK
GLDO
*The display blinks.
 3XVKWKH571EXWWRQWRDFWLYDWHWKHIXQFWLRQ
DQGUHWXUQWRWKHFXUVRUPRGH21LV
GLVSOD\HG
0RYHWKH FXUVRUWRWKH>0,;@LWHPDQGSXVK
WKH571EXWWRQWRVZLWFKWRWKHGDWDLQSXW
PRGH
 6HOHFWWKHPL[LQJPRGH\RXZDQWWRFKDQJH
E\VFUROOLQJWKH3XVKGLDO
*The display blinks.
 3XVKWKH571EXWWRQWRFKDQJHWKHPRGH
DQGUHWXUQWRWKHFXUVRUPRGH
:KHQ>0,;@LVVHOHFWHGDWWKH>0,;@LFRQWKHWKURWWOHFXUYH
GDWDWKDWLVVHWEHFRPHVWKHPL[PDVWHU:KHQ>810,;@LV
selected, the throttle stick position becomes the master.
ƔSRLQWFXUYHVHWWLQJ
0RYHWKHFXUVRUWRWKHSRLQWUDWHVHWWLQJLWHP
\RXZDQWWRDGMXVWDQGSXVKWKH571EXWWRQ
WRVZLWFKWRWKHGDWDLQSXWPRGH
 $GMXVWWKHUDWHE\VFUROOLQJWKH3XVKGLDO
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHa
*When the RTN button is pushed for one second, the servo
operation position is reset to the initial value.)
 3XVKWKH571EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVRUPRGH
5HSHDWWKLVSURFHGXUHIRUHDFKSRLQW
Ɣ1HHGOHKLJKWULPVHWWLQJ
0RYHWKHFXUVRUWRWKHQHHGOHKLJKWULP
VHOHFWLRQLWHPDQGDFFHVVWKHVZLWFKVHWXS
VFUHHQE\SXVKLQJWKH571EXWWRQ6HOHFWWKH
QHHGOHKLJKWULPOHYHU
)RUDGHWDLOHGGHVFULSWLRQRIWKHVHWWLQJPHWKRGVHH>6ZLWFK
Setting Method] at the back of this manual.
0RYHWKHFXUVRUWRWKH75,0UDWHLWHPDQG
SXVKWKH571EXWWRQWRVZLWFKWRWKHGDWD
LQSXWPRGH
 $GMXVWWKHWULPUDWHE\VFUROOLQJWKH3XVKGLDO
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHa
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)