FUTABA 12K - Page 147

147
<Model Menu (Airplane/Glider Functions)>
ƔSRLQWFXUYHVHWWLQJDLUSODQH
>&XUYHUDWHVHWWLQJ@
1. Move the cursor to the curve rate setting
LWHPOHIWVLGH\RX ZDQWWRDGMXVWDQGSXVK
the RTN button to switch to the data input
mode.
 $GMXVWWKHUDWHE\VFUROOLQJWKH3XVKGLDO
 $GMXVWPHQWUDQJHa
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 3XVKWKH571EXWWRQWRHQGWKHDGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>0RYLQJFXUYHSRLQW@
1. Move the cursor to the curve point setting
LWHP\RXZDQWWRDGMXVWDQGSXVKWKH571
button to switch to the data input mode.
 $GMXVWWKHFXUYHSRLQWE\VFUROOLQJ WKH3XVK
dial.
 $GMXVWPHQWUDQJH8SWRLQIURQWRIWKH
DGMRLQLQJSRLQW
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
 3XVKWKH571EXWWRQWRHQGWKHDGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>'HOHWLQJUHWXUQLQJFXUYHSRLQW@
Move the cursor to the curve point setting
LWHP\RXZDQWWRGHOHWHUHWXUQDQGSXVKWKH
RTN button for one second.