FUTABA 12K - Page 155

155
<Model Menu (Airplane/Glider Functions)>
ŏ6HOHFWWKHIXQFWLRQQDPH
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
TRIM MIX
>&RUUHVSRQGLQJPRGHOW\SH@*OLGHUDLOHURQVRUPRUH
This function adjusts the trim offset rates of the
DLOHURQVHOHYDWRUVUXGGHUDQGÀDSVFDPEHUÀDSV
EUDNHÀDSVDFFRUGLQJWRWKHÀLJKWVWDWXV
As an example this function can be set up for
ODXQFKLQJZLWKVSHHGÀDSVDQGDLOHURQVGURRSHG
and a slight amount of up elevator, and can be
XVHGIRUKLJKVSHHGÀ\LQJZLWKERWKDLOHURQVDQG
speed flaps reflexed slightly, and a bit of down
elevator.
To prevent sudden trim changes when switching
ÀLJKWFRQGLWLRQVDGHOD\FDQEHVHWWRSURYLGHD
ŏ6HOHFW>75,00,;@DWWKH0RGHOPHQX
and access the setup screen shown
below by pushing the RTN button.
*The display screen is an example. The actual
screen depends on the model type.
6FUROOLQJ
ŏ0RYLQJFXUVRU
ŏ6HOHFWLQJPRGH
ŏ$GMXVWLQJYDOXH
ŏ7RQH[WSDJH
smooth transition between the two conditions. It
is also possible to program a cut switch which
will turn off the delay.
Furthermore, you can set the auto switch, which
will link the trim mix to a stick, switch, or dial.
Additionally, the speed of the aileron, elevator,
UXGGHUDQGÀDSVHUYRVFDQEHDGMXVWHG
(Currently selected condition name)
ŏ&RQGLWLRQGHOD\
setting
ŏ$LOHURQVÁDSVHOHYDWRUV
and rudder servo
speed setting
ŏ$XWRVZLWFKVHOHFWLRQ
ŏ$LOHURQVIODSVHOHYDWRUV
and rudder offset rate
ŏ6ZLWFK
selection