FUTABA 12K - Battery and SD Card Operations

16
<Before Use>
Warning
Be careful not to drop the battery.
Never disconnect the battery connector
from the T12K transmitter after
turning off the power until the screen is
completely blank and the transmitter has
shut down completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error"
will be shown the next time when you turn on the
power of the transmitter. Do not use the transmitter as
it is. Send it to the Futaba Service Center.
ŬƑƖƗƄƏƏƄƗƌƒƑŃƄƑƇŃŵƈƐƒƙƄƏŃƒƉŃƗƋƈŃŷƕƄƑƖƐƌƗƗƈƕŃťƄƗƗƈƕƜ
NiMHBatteryHT5F1800B
Slidethebatterycoveroffthe
transmitterinthedirectionof
thearrowinthefigure.
Push
Inserttheconnectorofthe
batteryandloadthebattery
intothetransmitter.
Connectthebattery
connector.
Finishbyinstallingthe
batterycover.
Danger
When closing the battery cover, be
careful that the battery cover does
not pinch the battery lead wires.
Shorting of the battery lead wires may lead
to fire and abnormal heating and cause
EXUQVRU¿UHGLVDVWHU
Turnoffthetransmitter's
powerswitch.