FUTABA 12K - Page 172

172
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve Hold Curve
Ɣ3LWFK&XUYH([DPSOH
7KHVFUHHQVVKRZQEHORZDUHFXUYHVFUHDWHGE\
entering the pitch rate at low, center, and high side (3
points or 5 points) at each condition.
When actually creating a curve, input the rate
VSHFL¿HGE\WKHPRGHORUWKHUHIHUHQFHYDOXH
Curve setting examples
Pitch Trim (Hovering pitch, high pitch, low pitch)
>+RYHULQJSLWFKWULPVHWWLQJ@
Hovering pitch trim
7KH+RYHULQJ3LWFKWULPIXQFWLRQWULPVWKHSLWFK
near the hovering point. Normally, it is used with
WKHKRYHULQJFRQGLWLRQ7KHKRYHULQJSLWFKFDQEH
¿QHWXQHGIRUFKDQJHVLQURWRUVSHHGDFFRPSDQ\LQJ
FKDQJHVLQWHPSHUDWXUHKXPLGLW\DQGRWKHUÀLJKW
conditions. Adjust the hovering pitch so that
URWRUVSHHGLVFRQVWDQW7KLVIXQFWLRQFDQEHXVHG
WRJHWKHUZLWKWKH+RYHULQJ7KURWWOH7ULPIXQFWLRQ
for more precise operation.
Setting method
ŏ6HWWKHIXQFWLRQWR$&7>21@LQLWLDOVHWWLQJ
ŏ6HOHFWWKHDGMXVWPHQWNQRE
 6HOHFWLRQH[DPSOH/'LQLWLDOVHWWLQJ
ŏ7KHWULPRSHUDWLRQPRGH 0RGH&750
1250FDQEHVHOHFWHG
 CTRM mode:0D[LPXPDPRXQWRIFKDQJH
QHDUFHQWHUE\FHQWHUWULPRSHUDWLRQ
UHFRPPHQGHG
 NORM mode:1RUPDOWULPSDUDOOHO
PRYHPHQWWULPRSHUDWLRQ7KHDGYDQWDJH
RIXVLQJWKLVPRGH LVWKDWWKHKRYHULQJSLWFK
FDQEHDGMXVWHGZLWKRXWFKDQJLQJWKH
FXUYH
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKH
RSHUDWLRQGLUHFWLRQFDQEHFKDQJHG
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
 :KHQWKLVYDOXHLVPDGHVPDOOWULPFDQRQO\
EHXVHGQHDUWKHFHQWHU