73
<Functions of System Menu>
(Note) When this parameter is large, the current consumption increases.
• Buzzer
When the power supply of a servo is previously turned on at the time of a power supply injection without
taking transmit of a transmitter, the buzzer sound of about 2.5 Hz continues sounding from a servo.
(Even when the transmit of a transmitter is taken out previously, a buzzer becomes until the signal of a
servo is outputted normally, but it is not unusual.)
The transmitter has been turned OFF ahead of a servo power supply
→
The buzzer sound of about 1.25
Hz continues sounding as servo power supply end failure alarm.
(
Do not insert or remove the servo connector while the receiver power is ON. A buzzer may
sound by incorrect recognition.
)
＊
Buzzer sound is generated by vibrating the motor of a servo.
Since current is consumed and a servo generates heat, please do not operate the number more than
needed or do not continue sounding a buzzer for a long time.
To Next Page
Loading...
