FUTABA 16IZS - Prog,Mixes(ProgramMixing)

126
→ GO to TABLE OF CONTENTS
● Tap the [Prog. mixes] button in the Model menu to call
the setup screen shown below.
Program. mixes
Program mixing which can be freely customized. Up to 10
mixings can be used for each condition. [All model types]
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also
be used for unusual control congurations. Mixing
means that the motion of a command channel,
called the "master," is added to the motion of the
mixed channel, called "slave."
You may choose to have the Masters trim added to
the Slave channel response, if you desire ("Trim"
setting). The mixing curve can be changed so
that the undesired tendencies can be corrected
eectively by setting the EXP1/EXP2/Point modes.
Oset-type mixing applies a xed oset or preset
to the programmed channel servo operation and
may control up to four circuits simultaneously.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with
other programmable mixing functions. The link
function can be set up for Master and Slave channel
individually.
Fine tuning trim
setting
The on time (start/stop
time) can be set up to 4
seconds. It is useful for
landing gear control of the
jet or scale plane, etc.
●Group/single mode
switch (Gr./Sngl)
(For more information,
see the description
at the back of this
manual.)
Mixing/O󱐯set mode
switch
After this function is
activated, the master
and slave function
names (or o󱐯set mixing)
are displayed.
●Operation curve setting
(For a description of the
setting method, see the
description at the back of
this manual.)
Activate the function by
tapping the [INH] .
Trim mode setting ON/OFF.
The ON/OFF switch of
prog. mixes is chosen.
Master function
(or Stick, Switch, Dial)
is chosen.
Slave function is chosen.
Servo speed setting
●Return to Model menu