112
→ GO to TABLE OF CONTENTS
Telemetry : Airspeed sensor [Airspeed]
Displaying data from the airspeed
The speed screen displays and sets the speed
data from an SBS-01TAS (Airspeed sensor) sold
separately.
The speed of the aircraft during flight can be
displayed. After ight, the maximum speed during
flight can be viewed. Airspeed is the speed of an
aircraft relative to the air. You will be able to get a
more accurate aircraft speed.
*A Airspeed sensor must be installed in the aircraft.
Alarm setting when speed increases
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap Limit [xxx km/h].
4. Adjust the rate using the "▼▼" "▼" "▲" "▲▲"
buttons.
Adjustment range 0km/h~800km/h
(↑Limit
≧
↓Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the HOME/EXIT button.
Sets the speed on
which the alarm
operates.
● Tap the [Speed sensor] button in the Telemetry
screen to call the setup screen shown below.
Max. and min. values
since the power
was turned ON will
display.
Speed
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
*The Airspeed sensor is necessary, and is sold separately.
Mount and connect the sensor in accordance with the sensor
instruction manual.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
↑ An upward arrow
indicates the alarm
will sound when the
speed reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
speed reaches below
your set value.
●Return to
Linkage menu
Type 1
Type 2
Type 3
If the following types are selected, the transmitter
will vibrate during the warning.
To Next Page
Loading...
