65
→ GO to TABLE OF CONTENTS
● Long press the [U.MENU/
MON.] button in the
Home screen to call the
setup screen shown.
＜or＞
Each channel movement can be checked.
Select the [OFF] or pushing the
HOME/EXIT button→Testing is
stopped
[Neutral]: Mode which locks each servo in the
neutral position
[Moving]: Mode which repeats operation of
each servo
Servo monitor
Servo Test & Graph Display / Displays servo positions.
This is used for testing servo movement. “Moving
Test” (repetition mode) and “Neutral Test” (fixed
position mode) are available.
The “Neutral Test” is good for nding the neutral
position of a servo horn.
In order to prevent any potential difficulties,
the servo test function will be inoperable, or
inaccessible, under certain conditions. Specically,
the Servo Test function is not operational if the
Throttle cut is ON in either airplane or helicopter
modes; or if the Throttle hold is ON in helicopter
mode.
● Select [Servo monitor] at the linkage menu and
call the setup screen shown below.
WARNING
Don't set a servo test mode when the
drive motor is connected and the engine
has been started.
■Inadvertent rotation of the motor or acceleration of the engine
is extremely dangerous.
Test mode change :
OFF→Neutral→Moving
●Return to Home or
Linkage menu
To Next Page
Loading...
