FUTABA 4PL-2.4GHZ - Digital Trim Operation; Grip Lever Operation

DT3
DT4
ATL display
Steering D/R
display
DT2
DT1
Steering trim display
Throttle trim display
20
Before Using
Trim Operation
Digital Trim Operation
(Initial settings: DT1: Steering trim, DT2: Throttle trim,)
Operating by the lever: Push the lever to the left or right (up or down) The current posi-
tion is displayed on the LCD screen.
s%ACHSTEPISINDICATEDBYATONE
s7HENTHETRIMEXCEEDSTHEMAXIMUMTRIMADJUSTMENTRANGETHEBEEPWILLCHANGEANDTHESERVOWILLNOTMOVE
any farther.
s4RIMLEVERADJUSTMENTSHAVENOEFFECTONTHEMAXIMUMSERVOTRAVEL4HISPREVENTSTHELINKAGESFROMBINDING
when adjustments are made.
Grip Lever Operation
(Initial setting: DT3; Steering D/R, DT4; ATL)
Operate the dials by turning them. The current set value is displayed on the LCD screen.
s%ACHSTEPISINDICATEDBYATONE
s7HENTHETRIMEXCEEDSTHEMAXIMUMTRIMADJUSTMENTRANGETHETONEWILLCHANGEPITCHANDTHESERVOWILLNOT
move any farther.
With the center trim feature, trim adjustments have no effect on the maximum
servo travel. This prevents the linkages from binding when adjustments are made.