22
Before Using
Trigger Slide Adjustment
The throttle trigger position can be moved forward and backward.
Adjustment
1
Using a 2.5mm hex wrench, loosen the
trigger slide mounting screw by turning it
slightly counterclockwise.
2
Using a 2.5mm hex wrench, turn the trig-
ger slide adjusting screw, and adjust the
trigger slide position within the marked
range. When the adjusting screw is turned
clockwise, the trigger slide moves away
from the grip handle.
3
Retighten the mounting screw loosened at
step 1 and fasten the trigger slide.
Trigger slide adjusting screw
Adjust so that the bottom
mark does not exceed
the top marking line.
Trigger slide
mounting screw
ｎ
Warning
Antenna Moving Range
Adjust the antenna vertically
to the ground.
Antenna
AB
About The Transmitter Antenna
ｊ
Adjust the antenna vertically to the ground.
Otherwise, the operating range may become shorter.
ｌ
The antenna position can be changed in the range as shown in figures A and B. However, please
do not apply unnecessary force or shock.
The internal cable may be damaged; thus transmitting distance decreases and it may cause malfunction.
ｌ
Never hold only the antenna.
Hold the grip handle. Otherwise, the antenna may be damaged.
About Transmitter Antenna and Receiver
To Next Page
