The T10PX F-4G system provides the fastest Futaba response (as of 2022/5) when used in combination with the Futaba New UR
Servo. Follow the steps below to switch the settings. UR mode can only be used with F-4G systems. It can be used with T10PX
/ R404SBS (E) Ver.2 or later. Futaba WEB site https://futabausa.com/ Alternatively, download the data from the WEB site of the
local distributor and update the T10PX / R404SBS (E) to use it.
1. About Ultra Response UR Mode
ProcedureforchangingT10PXsettings
It is necessary to relink and restart the receiver power supply after changing the settings.
In the case of F-4G, 4 types of response settings can be set for each channel according to the servo
used. Select UR mode when using the UR servo set to UR mode.
・
UR mode
:
UR servo (Set to UR mode)
・
SR mode
:
UR/SR servo (Set to SR mode)
・
Digital servo
・
Analog servo
When using battery fail-safe, set the Battery Fail-safe Voltage in the "Fail-safe" in the "Linkage menu".
*In the F-4G system, the Battery Fail-safe voltage is set at the time of linking. Relink when changing
Battery Fail-safe voltage.
Use UR servo for steering
UR mode can only be
used with the F-4G.
&+
Set the transmitter "PWR" side power switch to ON. From the Home screen, press the HOME button
or tapped [Menu] on the touch panel. Next, select [Receiver] at the Linkage menu and access the set-
up screen shown below by tapping the screen.
1
2
3
HOME Menu Linkage menu Receiver
Receiver
Tap the Ch.1(Steering ) Tap the UR mode
"Please link the receiver
.
"
is display
Note:
In UR mode ON, normal servo, ESC, and standard gyro will not operate.
T10PX
Software Update
Ver.2.0