FUTABA T14SG - Page 6

2. Install speech data of T14SG
1. Please insert the SD card which includes the installing speech data.
2. Push the HOME/EXIT button.
3. Still holding the HOME/EXIT button, power
on the transmitter.
4. After a few seconds, the following screen is displayed.
5. Press the U.MENU/MON. button for three seconds. The
speech data begins to install.
6. After about 16 seconds, uploading reaches the right of the
progress bar, and then begins again after a pause.
7. The uploading may appear to progress slowly.
8. The progress bar will again upload. This can take a few
minutes.(About. 2 min.)
And, “COMPLETED” is displayed. Please turn o the power.
(Don't turn o the power before COMPLETED is
displayed.)
9. Please detach SD card.
10. Please check the language at TELEM.SET. menu in LINKAGE menu.
HOME/EXIT
button
U.MENU/MON.
button
INSTALLSOUND
START : PUSH MON . 3SEC
INSTALLSOUND
INSTALLING
INSTALLSOUND
INSTALLING
-6-
INSTALLSOUND
INSTALLSOUND
COMPLETED
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
©FUTABA CORPORATION 2013, 8 (1)