FUTABA T16IZ SUPER - Software Update Changes; Version 2.1 Software Changes

1M23Z09110
T16IZSUPERSOFTWAREUPDATECHANGES
V4.0
Thissoftwareupdatesoraltersthefunctionsandfeaturesnotedbelow.Theinstructionsandinformationthatfollowaremeantasasupplementtotheoriginal
instructionmanualthataccompaniedtheT16IZStransmitter.Pleaserefertotheoriginalinstructionmanualwhereapplicable,butreplacethestepsindicatedbelow
withtheseinstructions.Pleasechecktoensurethattheupdatehasbeeninstalled.
1)SelecttheSystemMenu.
2)Touchthe[Information]button.
3)Confirmthattheinformationinthedisplayindicatestheversionnumbersasnotedabove.
1.Receiversetting：ItisnowpossibletoconnectacompatiblereceivertotheS.I/Fportofthe
transmitterandconfigurethereceiversettings.
① ConnecttheS.BUS2portofthereceiverandtheS.I/Fportofthetransmitterwithacable.
② TurnonthepowerswitchwhilepressingtheU.MENU/MONbuttononthetransmitter.
③ Tap[Receiversetting]ontheSystemmenu.
Compatiblereceiversareasfollows.(AsofJanuary2024)
● R7208SB/R7308SB(Compatiblewithsoftwareversion2.0orlater)
● R7206SB/R7306SB
● R7214SB/R7314SB
SB2/RXport S.I/Fport
PresstheU.MENU/MONswitchandturnon
*For safety reasons, receiver settings
cannot be made while radio waves
are being transmitted.
2
1