FUTABA T16IZ SUPER - Page 5

⑤ Tap[Read].
⑥ TheDLPH-2settingswillbedisplayed.
⑦ ConfiguretheDLPH-2.
① ConnectthepowersupplytotheBAT.1orBAT.2portofDLPH-2.
③ TurnonthepowerswitchofDLPH-2.
S.I/Fport
RX1port
*Whensettingmodeissetto[Airplanegyromode],PWMoutputmodeisfixedto[1-16CH+DG1,DG2].
*T16IZScannotoperateafter17ch.
DualRXmode→SingleRXmode→Airplanegyromode→DualRXmode→．．．
1-16CH+DG1,DG2 → 17-24CH+DG1,DG2 → 1-16CH+DG1,DG2 →．．．
Modeselection
2.DLPH-2setting：ItisnowpossibletoconnectaDLPH-2totheS.I/Fportofthetransmitterand
configuretheDLPH-2settings.
② ConnecttheRX1portoftheDLPH-2andtheS.I/Fportofthetransmitterwithacable.
④ Tap[DLPH-2setting]ontheSystemmenu.