FUTABA T16IZ - Page 123

123
→ GO to TABLE OF CONTENTS
Conditions List
Currently selected condition name
ConditionCopy
1. Tap the [Copy] button. The Copy screen
appears.
2. Select the condition by tapping the button
of the copy source conditions.
3. Next, select the condition by tapping the
copy destination condition.
4. Tap the [Copy] button.
5. When the [Yes] button is tapped, the data
is copied. (To abort copying, tap the [No]
button.)
Condition Remove
1. Select the condition b y
tapping the condition you
want to reset in Conditions
List.
2. Tap the [Remove] button.
3. When the [Yes] button is
tap p e d , the c o n dition i s
reset. (To abort resetting, tap
the [No] button.)
Prioritychange
1. Tap the condition whose
priority you want to change
in Conditions List.
2. Change the priority with the
priority [
] or [ ] button. (The
last condition has the highest
priority.)
*The initial setting condition
cannot be moved. It has the
lowest priority.
Last condition has
the highest priority
Conditiondelaysetting
1. Switch to the condition you want to set.
2. Tap the Delay button of the channel you
want to set.
3. Use the value input buttons to set the delay.
●Initial value: 0
●Adjustment range: 0~27 (maximum delay)
● Group/single mode switching (Gr./Sngl)
(For a description of the operation
method, see the description at the
back of this manual.)
The ON/OFF switch of
condition is chosen.