FUTABA T16IZ - Page 187

187
→ GO to TABLE OF CONTENTS
FlightTune（Aileron/ElevatorBasicsettings）FlightTune（Aileron/ElevatorBasicsettings）
(3) Cnt. AuthAIL: Control Authority Aileron
Aileron Control Authority changes the rate at which the gyro will try to
achieve the set "CYC. Rt". A higher value will create a quicker accelerated
reaction to a stick input to reach and stabilize to the "CYC. Rt" value; a
lower value will reach the desired "CYC. Rt" slower and accelerate slower
to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression the
model is not following the pilot’s stick inputs. Values of between 20-60 are
the suggested range for most helicopters.
Settingranges:0~100%
Initialvalue:Cnt.AuthAIL=40%
(4) Cnt. AuthELE: Control Authority Elevator
Elevator Control Authority changes the rate at which the gyro will try to
achieve the set "CYC. Rt". A higher value will create a quicker accelerated
reaction to a stick input to reach and stabilize at the "CYC. Rt" value; a
lower value will reach the desired "CYC. Rt" slower and accelerate slower
to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression the
model is not following the pilot’s stick inputs. Values of between 20-60 are
the suggested range for most helicopters.
Settingranges:0~100%
Initialvalue:Cnt.AuthELE=40%
(5) EXPO.: Exponential
Tune the exponential as desired to change the feel of the cyclic controls
around center stick. Negative values soften control feel; Positive values
increase sensitivity.
Note: that any exponential present in the TRANSMITTER adds to the value
set in the CGY.
Settingranges:-100~0~+100%Initialvalue:-20%
(6) FLT. Styl: Flight style
Increasing this value will create a more robotic reaction to the stick, leaving
the pilot with the impression that the model is locked into in a position after
an input. It will also tend to have a more calculated feeling when making
inputs.
-Lowering the value will make the model feel more fluid and easy to rotate with
the stick input. The model will feel a little more lively during faster cyclic move-
ments and direction changes.
Settingranges:0~+100  nInitialvalue:+50  n
Cond
Cond
Cond
Cond