FUTABA T16IZ - Page 78

78
→ GO to TABLE OF CONTENTS
System type
■FASSTest 18CH ---
■FASSTest 12CH ---
■FASST MULTI ---
■FASST 7CH --- FASST-7CH system receiver mode. Up to 7 channels can be used.
■T-FHSS Air ---
■S-FHSS --- S-FHSS system receiver mode. Up to 8 channels can be used.
FASSTest system receiver mode. Applicable with the telemetry sensor unit. Up
to 18 channels (linear16+ON/OFF2) can be used.
T-FHSS system receiver mode. Applicable with the telemetry sensor unit. Up to
18 channels (linear16+ON/OFF2) can be used.
FASSTest system receiver mode. Applicable with receiver voltage display. Up to
12 channels (linear10+ON/OFF2) can be used. Telemetry Sensor cannot be used,
but the response speed is faster than that of the 18CH mode.
FASST-MULTI system receiver mode. Up to 18 channels (linear16+ON/OFF2)
can be used.
•
Analog servos cannot be used with the R7108SB in the FASSTest 12CH mode.
CRSF Protocol for TBS
T16IZ has been made compatible with the CRSF
(TBS) protocol.
*Bidirectional communication function of CRSF is not supported.
*When using CRSF, the S.BUS servo setting function and
[Reload] [Register] [Change slot] functions cannot be used.
When setting S.BUS servo and sensor, set CRSF to INH.
Tap the "CRSF" button to [ON]. A signal
conforming to the CRSF standard is
output from the S.BUS setting connector
(S.I/F) of the transmitter.
WARNING
Futaba is not responsible for damage
sustained by combination with
parts other than Futaba Genuine
equipment.
● Call page 2/2 from the [System type] menu.
*FASSTMULTI/FASST7CHcannotbeselectedforEurope.