To Next Page

To Previous Page

SWH.Detail（SwashDetailSetting）

(7) ELE PIT: elevator collective pitch mixing rate

During back and forward elevator inputs at middle collective, check if the

swash plate is raising or lowering during the input.

[Setting method] Operate the transmitter stick in the direction you want to

set. Touch the button lit in green to enter the setting mode and adjust the

mixing rate. Do the same for the other side.

Note: This setting can not be used when H4-00 swash mode is selected.

Settingranges:30~150%Initialvalue:H3-120=50%,exceptH3-120=100%

(8) ELE AIL: elevator aileron mixing rate

While moving the elevator back and forth at middle collective, check to

make sure the aileron axis is staying level.

[Setting method] Operate the transmitter stick in the direction you want to

set. Touch the button lit in green to enter the setting mode and adjust the

mixing rate. Do the same for the other side.

Note: This setting can not be used when H4-00 swash mode is selected.

Settingranges:30~150%Initialvalue:H3-120=50%,exceptH3-120=100%

(9) ELE ELE2: elevator 2nd elevator mixing rate

This parameter adjusts the elevator to 2nd elevator mixing rate. The rate

can be adjusted separately for up and down directions individually.

Note: This setting is only available if the H4-xx swash mode has been

selected.

Settingranges:30~150%Initialvalue:100%

(10) AIL High / AIL Low: Linkage compensation aileron

At HIGH pitch and LOW pitch check to make sure that the swash plate is

staying level on the elevator and collective axis when using aileron inputs.

If the swash plate is rising or falling:

[Setting method] Operate the transmitter stick in the direction you want to

set. Touch the button lit in green to enter the setting mode and adjust the

mixing rate. Do the same for the other side.

Note: check all four directions: high/right; high/left; low/right; low/left

Settingranges:0~100%Initialvalue:0%

(11) AIL Dir: Compensation direction of the aileron

If the above Data (+/-) correction from 0-100 is NOT in the correct compen-

sation direction, change the value from [+] or [-].

Setting:+/-Initialsetting:+

FUTABA T32MZ Manual

Other manuals for FUTABA T32MZ