Fyllo f8 - Trouble Shooting

- 13 -
17. T
ROUBLE SHOOTING
PROBLEM
CAUSE
SOLUTION
NO COFFEE IS BREWED.
THE WATER TANK IS EMPTY.
FILL WATER IN WATER AND FOLLOW FIRST USE
PROCEDURE.
THE COFFEE IS NOT HOT ENOUGH.
• CUP / MUG IS COLD.
• SCALE BUILD-UP IN MACHINE.
• PREHEAT CUP / MUG.
• DESCALE.
• BREWING A CUP OF WATER WILL PRE-HEAT
MACHINE.
COFFEE CAPSULE/POD WON’T EJECT.
• THE USED COFFEE POD CONTAINER IS FULL.
• THE COFFEE POD IS DEFORMED AFTER
BREWING.
• EMPTY THE USED COFFEE CAPSULE/POD
CONTAINER.
• PUSH USED CAPSULE WITH FINGER.
• USE PLASTIC KNIFE TO PUSH ESE POD DOWN.
STEAM ESCAPES WHEN HANDLE IS OPENED.
OPENED THE HANDLE TOO QUICK WHEN BREWING IS
FINISHED. THIS IS NORMAL FOR SOME STEAM TO
ESCAPE.
WAIT A FEW SECONDS AFTER YOU HAVE FINISHED
BREWING THE COFFEE TO LET THE RESIDUAL STEAM TO
ESCAPE.
WATER IS LEAKING OR DRIPPING AT BASE.
• WATER TANK IS LEAKING.
• DRIP TRAY IS FULL OF WATER.
• DRIP TRAY IS MISSING.
• CHECK IF THE VALVE ON WATER TANK IS STUCK
OPEN.
• EMPTY THE DRIP TRAY.
• MAKE SURE THE DRIP TRAY IS IN PLACE.
COFFEE POD DROPPED DOWN DIRECTLY TO THE USED
COFFEE POD CONTAINER.
COFFEE POD DEFORMED
TRY IT AGAIN WITH A SLIGHTLY DIFFERENT ANGLE.
USE A NEW COFFEE CAPSULE/POD OR ANOTHER BRAND
OF CAPSULE/POD.
OCCASIONAL DROPS DRIP OUT OF THE DISPENSING
HEAD.
THE INTERNAL HEATER IS KEEPING WARM.
OCCASIONAL DROPS ARE NORMAL, IT IS NOT A DEFECT.
COFFEE COMES OUT IN DRIPS/THE HANDLE IS HARD TO
OPEN.
THE GROUND COFFEE IN COFFEE POD IS TOO FINE TO
PASS WATER.
WAIT FOR 3 MINUTES TO OPEN THE HANDLE AND
CHANGE TO A NEW COFFEE POD.
MACHINE DOES NOT TURN ON.
NO POWER.
CONNECT POWER CORD AND TURN ON MACHINE.