6.
F
ILL
/
REFILL WATER TANK
BEFORE USING FOR THE FIRST TIME OR AFTER LONG
PAUSES (E.G. HOLIDAYS) THE MACHINE MUST BE
FLUSHED OUT. THIS SHORT PROCEDURE CAN FLUSH OUT
AND CLEANS THE INTERNAL PIPING THOROUGHLY.
THERE ARE TWO WAYS TO FILL THE WATER TANK:
DIRECTLY INTO THE MACHINE, BY USING FOR EXAMPLE A
JUG, OR BY REMOVING THE WATER TANK.
FILLING WITHOUT REMOVING THE TANK RAISE THE
WATER TANK LID. FILL THE TANK UP TO THE “MAX”
MARK WITH COLD FRESH WATER (THE MAXIMUM
CAPACITY IS 0.8 LITRE), OR AT LEAST THE “MIN” MARK.
7.
F
ILLING BY REMOVING THE WATER TANK
HOLD THE WATER GRIP AT TILTING
ANGLE AS SHOWN IN DIRECTION 1 TO
REMOVE THE WATER TANK FROM THE
MACHINE. FILL THE TANK UP TO THE
“MAX” MARK WITH COLD FRESH
WATER (THE MAXIMUM CAPACITY IS
0.8 LITRE). OR AT LEAST THE “MIN”
MARK.
SLIDE THE WATER TANK SLOWLY ON WATER TANK BASE, WHEN THE WATER TANK
OUTLET IS INSERTED IN THE INLET RECEPTACLE, PUSHING FIRMLY ON THE WATER GRIP
AS SHOWN IN DIRECTION 2 TO LOCK THE WATER TANK.
8.
F
LUSHING OUT THE MACHINE
FILL WATER TANK TO MAXIMUM LEVEL.
PLUG IN THE APPLIANCE AND TURN IT ON.
THE LIGHTS ON THE CONTROL BUTTONS WILL
BEGIN BLINKING, THE LIGHTS IN USED-CAPSULE
CONTAINER IS LIGHTED IN BLUE WHICH GOES OFF
AFTER 1 MINUTE.
TIP: YOU CAN CHECK EASIER IF THE USED
CONTAINER IS FULL OR NOT WHEN THE BLUE LIGHT
IS ON.
THE BUTTON LIGHTS BECOME STEADY WHEN THE
MACHINE HAS HEATED UP. HEATING UP TIME IS 45
SECONDS APPROXIMATELY.
To Next Page
Loading...