- 9 -
10.
R
EFILLING THE INTERNAL CIRCUIT WHEN WATER TANK IS OUT OF WATER DURING BREWING
IT IS STRONGLY RECOMMENDED THAT THERE IS ENOUGH WATER IN THE TANK BEFORE MAKING A COFFEE. THE MINIMUM LEVEL AT LEAST.
IN CASES WHERE THE WATER RUNS OUT DURING COFFEE BREWING IS COMPLETE, YOU CAN STOP THE BREWING PROCESS BY PRESSING THE SELECTED BUTTON WHICH IS BLINKING.
OPEN THE HANDLE TO EJECT THE USED CAPSULE. CAUTION: BEWARE OF HOT STEAM: DANGER OF SCALDING! FLUSH OUT THE MACHINE IN ACCORDANCE WITH “FLUSHING OUT
THE MACHINE”.
11.
E
NERGY SAVING MODE
THE MACHINE ENTERS ENERGY SAVING MODE AUTOMATICALLY ONCE THE MACHINE IS IDLE FOR 15 MINUTES. THE BUTTONS WILL FLASH CYCLICALLY IN ENERGY SAVING MODE. TO
QUIT ENERGY SAVING MODE, PLEASE PRESS ANY BUTTON, APPLIANCE WILL START TO WARM UP WITH LIGHTS BLINKING, WHEN THE BUTTONS ARE LIT STEADILY, THE MACHINE IS
READY TO BREW COFFEE.
12.
P
ROGRAMMING THE COFFEE VOLUME
MAKE SURE THE WATER TANK IS IN PLACE BEFORE BREWING. DANGER OF SCALDING!
1. MOVE THE HANDLE BACK COMPLETELY.
2. INSERT AN ESE POD OR A CAPSULE (DEPENDING ON MODEL) INTO THE COMPARTMENT CORRECTLY.
3. CLOSE THE HANDLE FIRMLY TO LOAD THE COFFEE ESE POD OR A CAPSULE.
4. PRESS THE DESIRED BUTTON AND KEEP IT PRESSED DOWN, ONCE THE DESIRED VOLUME HAS BEEN REACHED, RELEASE THE BUTTON, NOW THE BUTTON IS REPROGRAMMED.
5. AFTER THE PROGRAMMING, THE SIZE WILL BE RECORDED IN MEMORY. FOR NEXT USE, BY CLICKING THE BUTTON NORMALLY (PRESS ONCE.)
DO THE SAME FOR OTHER BUTTONS IF REQUIRED.
VOLUME RANGE: CONTROLLED BY TIME FROM 13 S~ 90 S (25ML ~150ML BASED. DEFAULT TIME IS 25S FOR SMALL CUP AND 48S FOR LARGE CUP.
TIP: THE BLINKING FREQUENCY IS 1 SECOND 1 BLINK, HENCE, YOU CAN COUNT THE BLINKING TO WORK OUT THE BREWING TIME.
To Next Page
Loading...