Fyllo f8 - Rewing Coffee

- 8 -
FLUSHING OUT THE MACHINE. (CONT.)
BEFORE PRESSING THE BUTTON, MAKE SURE THAT:
• THE HANDLE IS CLOSED WITHOUT COFFEE POD
INSIDE.
• THE WATER TANK IS FULL.
• THE WATER TANK IS FIRMLY IN PLACE,
OTHERWISE WATER MAY LEAK
• THE DRIP TRAY WITH THE USED COFFEE POD
CONTAINER IS COMPLETELY INSERTED (NEVER
OPERATE THE MACHINE WITHOUT DRIP TRAY
SET (PART D SHOWN IN “OVERVIEW OF
MACHINE PARTS AND CONTROLS”), OR HOT
WATER WILL RUN OUT WHEN OPENING
HANDLE.)
• A LARGE BOWL (250ML SIZE OR ABOVE) IS
PLACED UNDER THE DISPENSER.
PRESS THE LUNGO COFFEE BUTTON TO START FLUSH OUT.
• OPEN THE HANDLE WHEN THE FLUSH OUT PROCESS STOPPED
AUTOMATICALLY.
• EMPTY THE CUP.
• FLUSH OUT CYCLE IS FINISHED.
9. B
REWING COFFEE
PLACE AN EMPTY CUP UNDER THE DISPENSER. FOR SMALL CUPS, PULL DOWN THE
DISPENSING SPOUT.
1. MOVE THE HANDLE UP AND BACK COMPLETELY.
2. INSERT AN ESE POD OR A CAPSULE (DEPENDING ON MODEL) INTO THE
COMPARTMENT CORRECTLY.
3. FOR ESE PODS, SLIDE BACK THE ESE POD COVER BEFORE INSERTING POD.
4. CLOSE THE HANDLE FIRMLY TO LOAD THE COFFEE ESE POD OR A CAPSULE.
5. PRESS THE DESIRED COFFEE BUTTON ONCE.
6. THE SELECTED BUTTON WILL BLINK AND THE MACHINE WILL BEGIN BREWING
COFFEE, DISPENSING WILL STOP AUTOMATICALLY WHEN REACHING THE
DEFAULT BREWING TIME.
7. RAISE THE HANDLE TO EJECT THE USED C ESE POD OR A CAPSULE INTO THE
CONTAINER.
8. CLOSE THE HANDLE.
TIP: WHEN USING THE MACHINE IN THE MORNING OR IF THE IDLE TIME LONGER THAN
1 HOUR), IT IS SUGGESTED THAT YOU BREW WATER FIRST IN ORDER TO REMOVE THE
RESIDUAL TASTE OF THE LAST CUP.
DEPENDING ON THE MODEL OF THE MACHINE INSERT EITHER A CAPSULE OR A POD.
ESE PODS FOR ESE MACHINES
NESPRESSO®* CAPSULES OR
CERTAIN COMPATIBLE CAPSULE FOR CAPSULE
MACHINE