33
English
First installation
1 Remove the water tank (9), rinse it and ll it with cold water up to the MAX
level.
Circuit priming
The circuit must be primed upon machine rst operation or when the water tank is
empty:
1 Fill the water tank with cold water up to the MAX level.
2 Place a container under the Pannarello
3 Turn the steam/hot water knob counter clockwise and dispense water from
the Pannarello (8) until a steady jet comes out.
4 To nish dispensing, turn the steam/hot water knob clockwise and empty the
container.
Note: the machine does not signal a shortage of water in the tank; if the pump is
very noisy, rell the tank and prime the circuit.
2 Insert the power cord plug into a wall socket with suitable power voltage.
3 Press the on/off button (1), which will start ashing.
4 Place a container under the Pannarello (8), turn the steam/hot water knob (5)
counter clockwise and dispense hot water until all three on/off (1), coffee (2)
and steam (3) buttons ash simultaneously, signalling for you to turn the knob
off again.
5 The on/off button will come on steady and the coffee button (2) will start
ashing, turning steady once the factory set temperature is reached.
To Next Page
Loading...
