Page 16 of 32
Model 13352, 13362, and 13372 Addressable Amplified Speaker Assemblies Pub.: 43004-030A
d:\radio products-draft\gtc 43004\43004-030a\43004-030a.doc
06/05
Model BB133 Battery Back-up Kit
The Model BB133 Battery Back-up Kit provides up to 2.5 hours of continuous output (full power) if main
power is lost or disconnected. The kit includes an easily-installed battery bracket, Model 40201-010 2.8
Ah battery, and a single mounting screw. Refer to Publication 43003-036 for installation details.
Model 12506-001 Remote Volume Control Assembly
The Model 12506-001 Remote Volume Control Assembly allows local, mechanical control of the
speaker’s output volume. As previously stated, this is a passive adjustment. In this application, the
maximum output level is defined by the CARD Suite program. The Local Volume Adjustment can only
adjust the output level lower than the maximum programmed level.
PC Programming
All Addressable Amplified Speakers require the use of the XAC1000A CARD Suite programming
software application and the XAC0004A Programming Cable for the speaker for non-default settings.
The programmable settings are Volume Control, Generic or Selective Operation, and Activation Code
entry.
Models 13362 and 13372 RF speakers additionally require the use of the 19101-024 RF Module
Programming Kit. This kit includes a separate cable and software for programming the RF Module’s
operating frequency and TPL/DPL code. Refer to the programming instructions on page 19 of this
manual.
To Next Page
Loading...