3 - INSTRUCTIONS FOR USE
100
08
00
The set value is permanently lit on the humidity display
-
tion is activated.
If it is not activated the core probe display remains in a
cooking cycle. the cooking cycle is suspended.
All the set parameters are maintained.
The cooking time will restart from the suspended time.
The cooking cycle is resumed by pressing the START/
STOP key again maintaining the set parameters (pos-
sibly changed).
At the end of the cooking cycle:
The bell rings for 10 seconds or until the oven door is
opened and the oven is put in the OFF status.
Opening the door during the operation of the oven is
equivalent to pressing the stop key, but, when the door
is closed again, the oven resumes its operation automa-
tically.
TEMPERATURE KNOB
Adjustable from 0 °C to 270 °C
Temperature default value: 100 °C
During a cooking cycle the set values can be changed by
turning the temperature knob; at this point the display
COOKING TIME KNOB
Adjustable from 0.00 to 9.59
default value: 000
Selects the cooking time value in hours and minutes.
cooking mode and the display shows INF.
-
king mode you return to the minimum time.
PREHEATING
By turning the knob anticlockwise below 0.00 you acti-
vate the preheating function.
Instead of the time the display shows the message “PRE”.
When you start the cooking by pressing the START key
the oven begins to work and once the set temperature
is reached, the oven bell rings until the door is opened,
the values are zeroed and the user is back at the initial
stage of value setting.
Turning the knob clockwise the value on the display
turns to 000, the preheating function is disabled.
HUMIDIFICATION / DRYING KNOB
Adjustable from 0 to 100
Default 00
you set the value.
Turning the knob in the opposite direction once the va-
lue on the display is brought back to 0 the drying LED
turns on and the desired percentage of oven chimney
opening is set.
The higher the percentage, the more the chimney stays
open (100% total opening of the chimney).
HUMIDIFICATION KNOB
(only for the 523A model)
you set the value. During a cooking cycle the set values
can be changed by turning the knob at this point the
INF
PRE
To Next Page
Loading...
