RC1xx - User Manual
8 Ethernet address (RC120)
You may need to ask your network administrator for advice about setting
up the Ethernet connection.
The application note APP923 – Troubleshooting Ethernet problems is
available from www.gardasoft.com/Downloads.
The Ethernet set up of the RC120 is not affected by cold-booting the
controller.
8.1 IP address
The RC120 needs an Internet Protocol (IP) address to communicateover
Ethernet. There are two ways to get an IP address; either programmed
into the unit or using DHCP.
For DHCP mode, the TR-RC acquired its IP address, subnet mask,and
gateway address from the DHCP server. Otherwise the TR-RC has a fixed
IP address, subnet mask, and gateway address.
DHCP mode or the IP address can be set or read using the
GardasoftMaint program available from www.gardasoft.com/Downloads.
The GardasoftMaint window is shown below:
— 17 —
To Next Page
Loading...
