GARDASOFT RC100 - Setting the Internal Trigger Timer

RC1xx - User Manual
E-2
is displayed. Press the
SEL
button
to enter times values from 10ms to 5s.
Use the p and q buttons to select the
required value in steps of 10ms. Press
the
SEL
button.
Use the
p
and
q
buttons to scroll to
E-3
to enter time values from 1ms to 999ms.
Press the
SEL
button.
Use the p and q buttons to select the
required value in steps of 1ms. Press the
SEL
button.
Use the
p
and
q
buttons to scroll to
E-4
to enter time values from 0.1ms to
99.9ms. Press the
SEL
button.
Use the p and q buttons to select the
required value in steps of 0.1ms. Press
the
SEL
button.
10.2.7 Setting the internal trigger timer
You can set an internal trigger timer when the RC1xx is in pulse mode.
When set, the RC1xx triggers with the same delay and pulse width already
set up as described in Section 10.2.5, Setting up pulsed operation.
External triggering remains enabled.
Ensure the RC1xx is set to pulsed operation. To set the period of the
internal trigger timer, press and hold SEL for 1 second, and follow the
keystrokes below:
CH1
is displayed. Press the
SEL
button.
Use the
p
and
q
buttons to scroll to
FrE
and press the
SEL
button.
OFF
is displayed. Use the
p
and
q
buttons to scroll to
On
to set up the
internal trigger. Press the
SEL
button.
Set up the internal trigger timer as
described in Setting time values. Press
the
SEL
button.
The internal trigger timer is set.
— 27 —