RC1xx - User Manual
11.3 Event codes
On receipt of a GT1 command, event messages are sent by the RC120
over its Ethernet link when a light is connected or an error occurs. The
message format is:
Evt1,<event code>
Some event codes are displayed on the RC1xx’s front panel; these are
shown in red.
Event
number
Reason
1 to 127 An error has occurred. See Section 11.4, Error codes.
128 A light has been connected and is working.
129
A light has been connected but does not have a current
or voltage rating.
130 FAT
An over temperature error has occurred.
131 FAC
A over current error has occurred.
132
An error has occurred while autosensing the rating of a
light.
138 SafePower trainup has completed.
139 SafePower trainup has failed or been cancelled.
140
In switched mode, the light has been turned off because
the duty cycle is too high.
— 41 —
To Next Page
Loading...
