RC1xx - User Manual
rating. The firmware version number is then displayed, for example 001,
and then the unit is ready for operation. When the RC1xx is not being
configured, the display shows the status of the lighting output as shown
below:
The RC1xx displays an error if a light is connected but no rating specified.
To configure the RC1xx from the front panel, press and hold SEL for 1
second. CH1 is displayed. You can then use the p and q keys to scroll
through the menu, pressing the SELbutton to access the required set up
as shown in the table below:
Display Select to:
CH1
Set up an output channel
Eth
Set up Ethernet access
LOC
Set up a key lock
tES
(Factory test) Do not use
FrE
Set up the intetrnal trigger
trg
View the trigger status
UAL
View output current
rAt
Set the lighting rating
— 23 —
To Next Page
Loading...
