11
GB
Prog
OOFFFF
and Prog
11 11
:
Soil moisture sensor /
rain sensor and
Prog
11 11
:
Exit watering with
automatic water
distributor again:
The watering frequency entered for the first watering program
applies by design to watering programs 2
-
6 too.
1. Hold the Menu button down for 5 seconds.
Prog
and the program number flash on the screen.
2. Select program no.
11 11
with the knob and confirm with OK.
The ticker
Enter watering start time
appears.
Start
and the hour display will flash on the screen.
3. Set the watering start time (E.g.
11 88..0000
) and watering duration.
(E.g.
00::1100
) for program 1 (Prog
11
) (see
“Set watering program”
from Step 3).
4. Set the watering duration for programs
22
-
66
.
If after confirming Prog
11 11
the watering programs are turned off
(Prog
OOFFFF
) all programs starting at this time are reduced to the
minimum watering duration of 30 seconds. (Display: 1 min.). Thus
the watering programs are allocated correctly to the corresponding
outlet of the automatic water distributor.
By opening the water flow for a short time the outlets on the
automatic water distributor are switched on so that when the
programs are switched on again (Prog
OOnn
) or if a watering
duration is entered, the outlets to the required watering program
are allocated as they were originally.
If Prog
11 11
is selected and the soil moisture or rain sensor
registers sufficient moisture (Sensor OFF), a running watering
program is stopped.The time of the following waterings are
reduced to 30 seconds. (Display: 1 min.) until the soil moisture
or rain sensor allows watering again. Then the originally entered
watering duration is run again.
Reducing watering because the soil moisture is sufficient ensures
that the automatic water distributor switches to the next outlet and
thus the watering programs are allocated correctly to the relevant
distributor outlet.
v Hold the Menu button down for 5 seconds.
The normal display appears on the screen again.
2.
3.
To Next Page
Loading...
