Gardena C 1060 plus - Sensor-Controlled Watering (Prog 12-14)

12
GB
Soil moisture sensor-controlled watering
(Prog 12 - 14):
Condition: the GARDENA Soil Moisture Sensor Art. 1188 is
connected (see 4. Putting Your Water Computer into Operation).
The previously set programs for program-controlled watering
(Prog
11
to
66
are retained but they do not run.
1. Hold the Menu button down for 5 seconds.
Prog
and the program number flash on the screen.
2. Select the required watering cycle by turning the knob (e.g.
Prog
11 22
) and confirm by pressing OK.
Prog
11 22
Watering throughout the day (6a.m - 8 p.m.)
if the soil moisture sensor registers dry.
Prog
11 33
Watering during the night (8 p.m. - 6 a.m.)
when the soil moisture sensor registers dry.
Prog
11 44
Watering when the soil moisture sensor
registers dry.
Run Time
and the watering duration minutes flash on
the screen.
3. Set the watering duration in minutes (0 - 59 minutes) with the
rotary button (E.g.
4400
minutes) and confirm by pressing OK.
Watering starts in the set watering cycle as soon as the soil
moisture sensor registers dry (Sensor ON) .
The watering duration set in the sensor-controlled watering mode
also applies to manual watering.
In the case of soil moisture sensor-controlled watering, a
two hour watering pause is triggered after every watering
cycle in order for the soil moisture sensor to record the soil
moisture.
Example:
Watering cycle = Prog
1122
(Watering throughout the day)
Watering duration = 40 minutes.
Watering begins when the sensor registers dry (Sensor ON)
during the day (between 6 a.m. and 8 p.m.) and ends up to
40 minutes later depending on the amount of moisture in the soil.
The watering duration is preset to 30 minutes at the factory.
Emergency program:
If no sensor is inserted in sensor-controlled watering mode or if the
connection cable is faulty, watering will take place every 24 hours.
The watering duration depends on the run time but is limited to a
maximum of 30 minutes.
v Hold the Menu button down for 5 seconds.
The normal display appears on the screen again.
2.
3.
Exit soil moisture sensor-
controlled watering again: