6
GB
Connect soil moisture
or rain sensor (optional):
Compile watering plan:
Fit anti-theft device
(optional):
L
M
F
K
Program Start time Watering- Watering days Watering cycles
duration
Prog Start Run Time Mo Tu We Th Fr Sa So 24h 2nd 3rd 4th 5th 6th 7th
1 7: 30 0 : 30 X X X
2 19:00 0:20 X X
3 22:30 1:10 X X X
4 4:00 0:15 X
5 ––
6 ––
Apart from scheduled watering there is also the option of including
how damp the soil is or rainfall into the watering program.
If the soil is damp enough, the program will be stopped, or a
program will be prevented from starting. Manual operation via
Man. On / Off is unaffected by this.
The
“Soil moisture sensor-controlled watering”
mode can only
be selected when using a soil moisture sensor
(see 5.2 Special
programs).
1. Remove controller
F
from the housing of the Water Computer.
2. Place soil moisture sensor in the watered area
– or –
place rain sensor (with extension cable if necessary)
outside the watered area.
3. Insert the sensor in the sensor connection
K
of the Water
Computer.
An adapter cable may be required to connect older sensors,
which can be purchased from GARDENA Service,
GARDENA Adapter cable Art. No. 1189-00.600.45.
To secure your Water Computer against theft, you can obtain the
GARDENA Anti-theft device Art. No. 1815-00.791.00 from
GARDENA Service.
1. Screw clamp
L
with screw
M
firmly to the back of the Water
Computer.
2. Use clamp
L
e.g. for fixing a chain.
It is no longer possible to remove the screw after it has been
screwed in.
Before you start entering the watering data in the computer
we recommend that you write the data on one of the watering
plans in the appendix to maintain more of an overview.
Example:
To Next Page
Loading...
Need help?
General
