24
GB
3) 2 to 5 outlets are connected without a sensor:
If fewer than 6 outlets are used, and no sensor is employed,
the programmes must be programmed as usual (see
5. Programming). All programmes must have the same cycle
and there must be minimum pauses of 5 minutes between the
programmes so that secure further switching is guaranteed.
7. Putting Your Water Computer out of Operation
1. Press Menu-key 3 times, select Prog. Off (Run-Time
0
%)
with the
+-key and confirm with the OK-key.
The watering programs will not run.
2. Store controller and valve unit in a dry place where they are
protected from frost.
Over-wintering /
storage:
To Next Page
Loading...
