32 - English
3. INSTALLATION
3. Select Home mode by pressing the house symbol
key and pressing OK when the cursor is at Home.
Press Start and close the cover.
4. Check that the mower follows the guide wire all the
way to the charging station and that it docks with
the charging station. The test is approved only if
the mower is able to follow the guide wire the
entire distance to the charging station and dock at
the first attempt. If the mover is unable to dock on
the first attempt, it will automatically try again. The
installation is not approved if the mower needs two
or more attempts to dock with the charging station.
In this case, check that the charging station, the
boundary wire and the guide wire are installed in
accordance with the instructions in Chapters 3.2,
3.4 and 3.6.
5. The mower will stay in the charging station until
Auto or Man mode is selected. See 5.1 Operation
selection on page 37.
The guide system must first be calibrated if the above
test is to provide a satisfactory result. See 3.8 First
start-up and calibration on page 31.
To Next Page
Loading...
Need help?
General
