Page 31
User Manual
GARDTEC
800 Series
12) If you wish to accept the User Name shown press
YES and jump to step 17
Or
If you wish to change the User Name shown press
NO, the display will show:-
13) You may now enter up to nine characters for
the user name using the layout shown below
for the allocation of characters.
14) Referring to the character map enter the required
character (pressing the 3 key will display 'G', pressing
it again will show 'H' and again will show 'I '), once
the correct character is displayed press YES and the
display will move on to the next position.
15) Continue entering characters (up to 9). If
you require a blank space press YES while
the '-' is displayed
16) As you press YES for the ninth character
(or if you have jumped from step 12) the
display will change to:-
17) If you wish to program other User Codes
return to step 4
Or
Press 0 to return to:-
User 02 Name
= User 02
User 1 Name
>
To Next Page
Loading...
