Keypad Alert - If Fitted
If programmed by your installation company, the two PA keys (if programmed
by the engineer), when pressed together will act as alert keys. The exact function will
depend on what they have been programmed for. But for example, if they are pro-
grammed as panic, pressing them will activate the alarm when the system is set or
unset.
Keypad Tamper
The keypad will monitor the number keys that are pressed without a valid User Code
being entered. More than 24 key presses will cause a keypad tamper. This will be
displayed as Keypad x Tamper and will require a valid User Code entry to stop the
sounders. If the system was Unset only the internal sounders will operate. If the
system was Set, a full alarm will be generated.
System Tampers
The full security system is tampered, any attempt to remove covers from Keypads,
Control Panel, Keypads, Bell Box(es) or detectors will cause a tamper alarm. This also
applies to cut cables. If the system is Unset when the Tamper occurs the alarm will be
internal sounders only. If the system is Set a full alarm will be generated.
The alarm may be silenced by entering a valid User Code. The system may only be
Reset when the Tamper has been cleared, otherwise another Tamper alarm will be
generated.
User Manual
GARDTEC
800 Series
Page 40
To Next Page
Loading...
