Programming Group Area User Codes
1) With the display showing:-
2) Enter a Master Code, the display may show:-
3) Press NO five times, the display will show:-
4) Press YES, the display will show:-
5) Enter the user number (1 to 99) that you
wish to program followed by YES, the
display will show:-
6) Either enter the User Code you require
followed by YES
Or
Present your G-Tag to the Reader
The display will show:-
7) Press NO until the Code Type you require is
displayed (Grp-Mast). Then press YES.
The display will show:-
Note: This screen will not appear if User No.1 is being
programmed. Group Codes are not available for
User No.1.
8) Use the keys 1 - 7 or 0 for C (Cleaner) to toggle
the Area/s you wish to control with this code.
When finished, press YES. Display will show:-
9) Press YES.
01 JAN 18 : 58 : 01
Do you want to . .
SET the System ?
Do you want to . .
Prog. USER CODES ?
Enter User No. - -
(1- 99) Then YES
Now Enter Code . .
- - - - - - Then YES
Code Type
= Master ok ?
Assigned Area/s
= 1234567C ok?
Code Group
=None ok ?
GARDTEC
800 Series
User Manual
Page 33
To Next Page
Loading...
