Enter Programming
1. PRESS and HOLD the button
for approximately 3-5 seconds. The
controller will display the control
model number and the current version
Eprom Chip.
Disable Multi Gap Cooking
2. PRESS the button 2x. The
controller will display “SYSTEM SETUP”.
3. PRESS the
button until the control
displays “MULTI GAP (Yes/No)” - If
control displays “NO”, move to step 6.
4. PRESS and HOLD the button until
the “YES” begins to ash.
5. PRESS the button to change the
MULTI GAP setting to “NO”.
6. PRESS the button 2x. The
controller will display “MENU ITEMS”.
Remove menu items from menu library
7. PRESS the button until “FOLDED
EGGS - FLAT - YES” appears in the
display.
CONTROL PROGRAMMING
8. PRESS the button to change the
“YES” to “NO”.
9. PRESS the button until “ROUND
EGGS - FLAT - YES” appears in the
display.
10. PRESS the button to change the
“YES” to “NO”.
Change settings for current menu items 10:1, 4:1, Sausage, Grilled
Chicken, Bacon, Angus, Mushrooms & McRib.
11. PRESS the button 2x. The
controller will display “SYSTEM SETUP”.
12. PRESS and HOLD the button until
“GAP CALIBRATION” appears in the
display.
13. PRESS the button 2x. The
controller will display “MENU ITEMS”.
14. PRESS the button to select “10:1 -
CLAM YES”.
15. PRESS the button until “REMOVE
TIME - ###” is displayed.
16. Using the and button, change
the old setting to the new setting.
17. PRESS the button until “GAP
SETTING - ###” is displayed.
18. Using the and button, change
the old setting to the new setting.
FOR USE WITH MODELS MWE-9501 / MWG-9501
PAGE 1
9501ProgrammingNew.indd
Last Updated (081310)
GC 450 V 7.3#
SYSTEM SETUP
SYSTEM SETUP
GAP CALIBRATION
MENU ITEMS
10:1 CLAM YES
REMOVE IN ###
REMOVE IN ###
GAP SETTING ###
GAP SETTING ###
MULTI GAP - YES
MENU ITEMS
FOLDED EGGS-FLAT YES
FOLDED EGGS-FLAT NO
ROUND EGGS-FLAT YES
ROUND EGGS-FLAT NO
MULTI GAP - YES
MULTI GAP - NO
The following procedures should be followed in sequence. If
you have trouble following the steps listed below, you can
consult your operations manual. A downloadable copy of
the Operations manual containing additional programming
instruction can be found at https://clamshell.garland-group.
com/literature.asp.
1. Enter Programming - Enter the program mode.
2. Disable Multi Gap Cooking - Not used anymore.
3. Remove existing menu items from library - Remove
Folded Eggs & Round Eggs (FLAT) from library, these items
will be reprogrammed as CLAM menu items.
4. Change settings for the remaining menu items in library
- Change existing menu items to the new programmed
settings.
5. Program new menu items into library - Reprogram Egg
products into CLAM menu items.
To Next Page
Need help?
General
