Charging the Dog Collar Device
NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the
charging clip.
NOTE: Your dog collar device may look different than the device pictured.
You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery
takes about five hours.
1 Snap the charging clip onto the device .
2 Plug the small end of the power cable into the mini-USB port on the charging clip cable.
3 Plug the power cable into a power source.
The status LED is solid red when the collar is charging.
4 After the status LED turns solid green, remove the charging clip from the collar.
Turning On the Device
• On the handheld device, press the power button.
• On the dog collar device, hold the power button until the status LED flashes and the collar beeps.
Turning Off the Device
• On the handheld device, hold the power button and select Power Off.
• On the dog collar device, hold the power button until the status LED turns red.
Selecting a Language
When you turn on your device for the first time, you must select the device language from a list of available
languages. You can change the language setting from the System settings.
1 Press the menu button.
2 Select Setup > System > Language.
3 Select a language.
Getting Started 5
To Next Page
Loading...
