What does 'ACTIVATION REQUIRED' mean on my Garmin G1000 Avionics Display and how to fix it?
The 'ACTIVATION REQUIRED' message on your Garmin Avionics Display indicates that the XM Data receiver is not activated. You will need to activate the XM Data receiver to resolve this.
What does 'OFF AIR' mean on my Garmin G1000 Avionics Display?
If your Garmin Avionics Display shows 'OFF AIR', it means the selected channel is not in service. Select a different channel to continue.
What does '---' mean on my Garmin G1000 Avionics Display?
The '---' on your Garmin Avionics Display indicates missing channel information. Check if the channel information is available.
What to do if Garmin G1000 GDU 1040 MFD or PFD does not power up?
If your Garmin Avionics Display GDU 1040 MFD or PFD doesn't power up, take these steps: * Ensure that the necessary criteria are met for the situation. * Check that power is present at the display backshell connector. * If neither of these steps works, the display may need to be replaced.
General| Display Type | LCD |
|---|---|
| Primary Flight Display (PFD) | Yes |
| Multi-Function Display (MFD) | Yes |
| Terrain Awareness | Yes |
| Autopilot Integration | Yes |
| Integrated Flight Deck System | Yes |
| Weather Radar | Optional |
| Traffic Advisory System (TAS) | Optional |
| Terrain Awareness and Warning System (TAWS) | Yes |
| Resolution | 1024 x 768 pixels |
| Weather Data | Yes |
| Navigation | Yes |
| AHRS | Yes |
| Air Data Computer (ADC) | Yes |
| Interfaces | ARINC 429, RS-232 |
| Certification | TSO certified |
| Traffic Information | Optional (requires ADS-B or TCAS) |
Lists the necessary test equipment for post-installation checkout procedures.
Verifies compatibility between G1000 hardware and the loader card.
Outlines the sequence for software and configuration loading for the G1000 system.
Verifies software part numbers and versions against the required equipment list.
Describes configuration steps for optional systems installed in the G1000.
Provides solutions for common software and configuration loading issues.
Verifies G1000 discrete inputs and outputs in configuration mode.
Details calibration procedures for aircraft systems like trim, fuel quantity, etc.
Performs initial calibration procedures for AHRS and magnetometer units.
Covers magnetometer calibration and engine run-up vibration tests.
Tests secondary communication paths and failure modes for GIA, displays, AHRS/ADC.
Verifies the AFCS pre-flight test sequence and annunciations.
To Next Page