Garmin G3000 User Manual

REFERENCE ONLY
1
Version 1.0
REFERENCE ONLY
Swapping GSA80 Roll & GSA80 Yaw Servo on Citation CJ3+
Garmin G3000 Software Version 10
Caution: Before starting the software or configuration loading process, certain
items may be required to be recorded first, to prevent loss of
information or settings. See Section 1 for details.
Caution: Make certain that all SD cards are available before starting. These are
usually located in a blue pouch onboard the aircraft (usually in AFM).
Caution: Follow all steps in a given section for specific loadings. Failure to do so
will result in probable rework.
Caution: Ensure that power is available through a GPU so that power is not
interrupted during the loading process.
Note: This document is to supplement, not replace, the Cessna Citation CJ3+
MM, and Garmin G3000 LMM.
Note: Reference latest revision of the Garmin G3000 LMM 190-01785-00.
Table of Contents
Introduction G3000 System Familiarization
Section 1 Determining Options Installed
Section 2 Software and Configuration Loading
Section 3 Final Verification / Return to Service
Section 4 FLEET ID / CRC Numbers
Section 5 Troubleshooting

Garmin G3000 Specifications

General

Display Type	LCD
Communication	VHF COM, SATCOM
Synthetic Vision	Yes
Operating System	Proprietary Garmin OS
Connectivity	Wi-Fi, Bluetooth
Power Supply	28 V DC
Certification	FAA, EASA
Resolution	1024 x 768 pixels
Interfaces	ARINC 429, Ethernet
Navigation	GPS, VOR, ILS
Weather	Radar
Suitable Aircraft	turboprops
Charts	Jeppesen
Display Size	14 inches
Type	Integrated Flight Deck System
Processor	High-performance multi-core processor
Weight	Varies depending on configuration
Dimensions	Varies depending on display size and configuration

Summary

Section 1 Determining Options Installed

Synthetic Vision

Verify the presence of the Synthetic Vision display option on the PFD.

Checklist System

CPDLC

GSR56 Satellite Communication Options

ACARS System

GDL69 (XM Receiver)

GSR56 Weather

Stormscope (Lightning Detect)

Doppler & Turbulence

Ground Clutter Suppression (Stand Alone)

Cabin Briefing

SurfaceWatch

Becker ADF

GDR66 (VHF Datalink)

HF9000

DME 2

TAWS Class A

EROS Oxygen Mask

ACARS Service Provider

TAWS A Voice Callouts (100-400 FT)

SurfaceWatch Voice Callouts

Section 2 Software and Configuration Loading

GSA 80 (Roll & Yaw Servos) Loading

Steps to load software and configuration into GSA 80 servos after swapping.

Section 3 Final Verification / Return to Service

Verification of Installed Options and FLEET ID

Review installed options, compare to Section 4, and verify FLEET ID match.

Section 4 FLEET ID / CRC Numbers

Determining FLEET ID and CRC Numbers

Guide to determining the correct FLEET ID or CRC number based on installed options.

Section 5 Troubleshooting

Fail Message During Software & Configuration Loading

Procedure for acknowledging and resolving fail messages during loading.

*** DB Error or *** DB Mismatch

Troubleshoot database mismatch errors by verifying SD cards and reloading.

*** Manifest Error

Troubleshoot manifest errors by checking work and reloading software.

*** Config Error

Troubleshoot configuration errors by checking work and reloading configurations.